S-26 Liquid Plastic Solutions

S-26 Epoxy Enamel Coating

Marine & Industrial

S-26 Epoxy Enamel Coating

S-26 Epoxy Enamel Coating(Twin Pack) is designed for table tops, fibreglass finishes, wooden surfaces, metal doors and cranes – where extreme use is anticipated.

Packaging:

1L, 5L, 20L

Spread rate:

1 litre= ± 6m², depending on the substrate

Colours:

Grey, Charcoal, White, Terracotta Red, Mid Green

Finish:

Satin

Outstanding characteristics:

Non-yellowing
Light-fast
Sets quickly and begins to cure immediately after application
Extremely durable
Seamless coating
Easy to maintain.

Suitable for:

  • Fibreglass
  • Metal
  • Wood

Application:

  1. See our Preliminary and General Notes
  2. Allow plenty of ventilation in confined areas and never allow ignition, smoking or naked flame when application is taking place.
  3. Never apply onto a damp or wet surface.

Application on fibreglass:

  1. Prepare the surface: Always sand down the fibreglass surface to flat and remove to gloss finish. Failure to observe this will result in S-26 Epoxy Coating pealing and flaking.
  2. Use a suitable quick-drying solvent to remove all traces of dust.
  3. Mix 4:1 base to hardener, using a small electric drill.
  4. Apply two to three coats of S-26 Epoxy Enamel, giving no more than 12 hours at >20°C to overcoat.

Application on metal:

  1. Prepare the surface. Remove as much rust and dust as possible.
  2. Apply one coat of S-26 Zinc Rich Epoxy Primer.
  3. Mix 4:1 base to hardener of S-26 Epoxy Coating, using a small electric drill.
  4. Apply two to three coats of S-26 Epoxy Enamel, giving no more than 12 hours at >20°C to overcoat.
  5. Pot life once mixed is three to nine hours, depending on the ambient temperature.
  6. An industrial fan will increase air circulation and will assist in the product drying and curing.
  7. Three to seven days full cure, depending on the temperature.

NEVER DILUTE THE PRODUCT!

Application tools:

  • Brush
  • Spray
  • Roller